HI Q PARTS ONE-TOUCH CONNECTOR LED SERIES VOL.2: 4 BRANCHES BOARD ALWAYS-ON (FOR BTBUSB) (1PCS) japan NEW

Electrical parts (motor / switch / lights)

"One Touch LED Series 2" is a board-based lighting system specialized for models

A specially designed LED lighting system specially designed for model incorporation.
Based on USB power supply, it is assumed to be installed in mechanical models, car models, and diorama.
The concept is “It can be used just by inserting. No prior knowledge of LEDs is required.
Functions can be added by simply connecting boards such as power supplies, switches, and branches.
The board is designed for a model and is small enough to fit in a 20mm square.
This is a new series that covers everything from beginners who are new to electric lighting to middle users who want to build medium-sized electric lighting systems.

Feature 1 ・ Minimal connector
The connector is designed so that it can only be inserted in the correct orientation.
Please be careful not to insert it forcibly.
A new standard that uses a tiny connector.
If there is a hole with a diameter of about 3 mm, the wiring can be passed along with the connector.
If you want to pass it through a narrower place, make a slit hole about 0.7mm in the part you want to pass and slide only the wiring.

Feature 2-Pre-wired ultra-small LED
The tip of the light emitting part is about 2 mm.
A variety of color lineups are planned.
Regardless of the color of the LED lamp to be connected, any color that is compatible with the series can be used at the same time.
By using a branch board, up to 10 lights can be turned on simultaneously (when using BTBUSB).
The lighting pattern can be changed by using a branch board that has already been programmed.

Feature 3 Dedicated design board
Necessary functions are concentrated on a dedicated design board of about 2cm square.
We made it as thin and small as possible so that it can be easily incorporated into the model.
Even the thickest part has a thickness of 3.8mm.

Feature 4-Notch for screw fixing
Notches for screwing are provided so that the board does not wobble when the switch is turned on or off or the cord is inserted or removed.
It is a common layout that is convenient when you want to stack two boards in a stack.
Recommended screw: M1.6 × 4mm, M1.6 × 8mm
* Pilot hole 1.3mm

(From HiQParts website)