GOD HAND Metal Line Nippers japan NEW

[Size] Overall length: Approximately 130 mm Metal wire dedicated nippers that support metal wires from 0.042 mm to 2 mm! !! ・ A double-edged nipper dedicated to metal wires that focuses on Φ2 mm brass wires from the metal lines used in model making. It is possible to cut with a "flat cross section" instead of the "crushed cross section" that is often found in general metal wire nippers! This one can be widely used for metal wires used in models. ・ Beautiful cross section ・ Short finishing time Since it is cut without crushing it as flat as possible, it crushes and swells, and the shaft diameter etc. does not change. ・ By applying a special blade, it can be used for all sizes. It can also be used for cutting metal wires of various sizes, from 0.02 (0.042 mm) metal wires to Φ2 mm brass wires! ■ Product description ・ Adopts God Hand's original blade attachment technology "Hybrid Edge". The blade attachment is different between the tip side half and the root side half when viewed from the center of the blade, and this one can handle from ultra-fine wire to 2 mm wire. Specializing in wire cutting from 0.5 mm or less on the tip side and 0.5 mm to 2 mm on the root side ・ Blade so that the cut surface of the target wire is as flat as possible. ・ It is possible to cut with a light force compared to nippers of the same size (compared to God Hand). ・ Handmade one by one by a veteran blade sharpener ■ Quality notation ・ Double-edged nippers for metal wires ・ With spring ・ Overall length: Approximately 130mm ・ Soft grip ・ Blade hardness: HRC56 or higher ・ With cap ■ Maintenance ・ If you touch a metal part with your finger, wipe off your fingerprints and apply oil. Sebum can cause rust, so be sure to wipe it off with a clean cloth. ・ Regularly add rust preventive and lubricating oil such as nipper maintenance oil. If the lubrication performance deteriorates, rattling will occur and it may cause damage. ・ After use, attach a cap and store. ■ Notes ・ Do not cut anything other than the target wire. ・ For safety, please wear protective goggles. ・ Because the object may fly, make sure that there are no people around and that there are no fragile objects before starting work. ・ Do not touch the cutting edge directly. ・ Do not apply more load than the capacity. Pay particular attention to the load on the tip. ・ To prevent rust, wipe off dirt and fingerprints, and lubricate the shaft and cutting edge. ・ Store in a case out of the reach of small children.