HI Q PARTS DP BOTTLE JP FOR 30ML (1PCS) japan NEW

"Modeling / Modeling auxiliary tool

[For diluted paint for airbrush. Added small 30 ml type to a convenient dropper bottle which can open and close caps with one touch]

The DP bottle is a dropper bottle containing model paint diluted to about 3 times.
It opens by twisting the tip and aims to pour it immediately into the cup of the airbrush handpiece.
Tighten the tip in the reverse direction.
It is a bottle characterized by being able to open and close without removing the cap.
The paint put in it is assumed diluted paint.
Those with very high viscosity may stick at the tip and clog.
We are assuming 3-fold dilution (about water).

Thinner for the model can be put in, but deterioration of the container has been confirmed with some primers such as thinner used for car painting and thinner for cleaning.
Please be sure to test when placing a strong solvent etc. above.

Capacity / 30 ml
Ceramic ball for stirring
Producer / Japan

・ Following 60 ml, 200 ml, 30 ml small capacity type was added.
- It is a compact size to fit in the palm of your hand.
・ It is graduated to understand capacity.
It will not dissolve in model solvents, but some powerful solvent will melt, so if you want to clean it please use the one sold for model use.
・ Remove labels.

[Digression]
60 ml, 200 ml and produced it last, the size is 30 ml.
Other, we plan to sell a single item with packing.
Originally 30 ml size, the mold was able to be diverted since it existed in the manufacturing place, but because the bottom is round, it often falls down when putting paint, so you can not use it, you need to make a new mold. did.
Therefore, budget is necessary, it became release after a considerable period of vacation.
Although the new design is difficult to collapse, the ground contact area is about half of 60 ml.
Please be careful not to fall over at the desk etc.
Petatch is recommended for printing labels.
Laminated seals can be printed, so printing will not disappear even when solvent is applied.
Brother Petatch.
A laminate can be used as a standard, and a seal which can not be erased with a solvent can be printed.
it's recommended.

[In addition]
About stirring ball.
Early we put glass balls.
Currently we are putting ceramic balls.
The cost has increased, but the weight has decreased.
Metallic spheres can not be used for many purposes because metallic spheres have paint that reacts, so it is often used as a stirring sphere for glass and ceramics (it is like a stone) as a stirring ball.
Stainless steel 304 seems to have less effect, but we believe that it is desirable that the stirring balls be nonmetal with no potential difference avoiding electrolytic corrosion.
The reason why it became a ceramic sphere from the middle is to ensure that the ingredients accumulated on the curved surface (mainly bottom R) inside the container are properly mixed.
In the case of a glass bulb of the size I was using, paint may remain on the corner and it did not mix well.
However, since ceramic balls are not as heavy as glass bulbs, glass beads do not start to agitate earlier.
If you want to mix high viscosity paint, hitting the bottom corner of the DP bottle with a soft one will be mixed quickly.

(From the HiQParts website) "