GOD HAND Ultimate Nipper 5.0 japan NEW

The Ultimate Nipper is a nipper that specializes in gate cutting for the "ultimate cut". When I sliced a runner about 3 mm in diameter, the blade slid in and finished cutting almost without a sound. Ultimate Nipper Cutting Because of its sharpness, it produces a smooth cut surface that resembles that of a design knife and minimizes plastic bleaching (a phenomenon that causes the cross-section to turn white). It is recommended for those who want to complete a plastic model without painting, because the cutting mark is much cleaner than a general nipper. Comparison of sharpness with general nippers (GN-125 is used here) Comparison of sharpness of nippers For painters, it's a great time-saving tool because it minimizes the need for files and knives to process the gates, since there's no trace of the cut when you run the blade along the part and cut it without leaving a gate. When cutting out small parts, the parts are less likely to pop off, and you don't have to search for the missing parts. Cut small parts. It can be cut quickly and easily without using any force, so it is less tiring even after a long time of cutting. The standard force for cutting 3mm diameter plastic is less than 2kg (general nippers are 3.5-10kg). -The "cutting edge" and "one-blade structure" in pursuit of sharpness What makes the Ultimate Nipper so amazingly sharp is its thin, sharpened "kiriba" (cutting edge) and its single-blade construction for a cleaner cut. Ultra-thin "cutting edge" by craftsmanship The "cutting edge" is thin and sharp like a knife and is the life of the Ultimate Nipper. This "cut blade" is produced by the craftsman in Tsubame-Sanjo, Niigata Prefecture, which is famous for its cutlery, carefully cutting and sharpening one by one. Single blade construction for clean cutting In order to obtain a clean cutting surface, the Ultimate Nipper uses a "single blade construction". The "single-edged structure" is a structure in which one side of the blade is the "cutting edge" and the other side is the "cutting board blade". It is called "one-blade" because there is only one blade (cutting edge) that can be cut. The "cutting board blade" holds the object to be cut firmly, and the force of gripping the grip changes directly into the force to move the "cutting blade". The wide cutting board blade supports the cutting board from the bottom, so deformation during cutting can be minimized. -Cutting board blade" for reliable cutting The "cutting board blade" of the Ultimate Nipper is slightly more protruding than the "cutting blade". As a result, there is a very slight difference in the cutting surface. This specification was made to prioritize "reliable cutting" rather than making the cutting surface flat (no steps). No matter what kind of nippers you use, they will gradually become rickety as you use them. If the "cutting board blade" and "cutting blade" are flat, the "cutting blade" will come off the "cutting board blade" even if there is a slight wobble. If this happens, it will not be able to cut properly or, in the worst case, it will cause the blade to break. Therefore, when the blade is closed, the "cutting blade" is adjusted so that it comes to the center of the "cutting board blade" so that it can cut properly even if there is a little rattling. On the other hand, the cutting board blade and the cutting blade are not flat, so even if you put both blades in close contact with the parts and try to cut without leaving a gate, it is easy to leave a cut. -Functions of each part Anti-open pin It prevents the spring from coming off if the blade opens too much. It has changed from a traditional metal pin to a resin pin. The tapered shape of the pin prevents the pin from being pushed into the hole due to collision, etc. The pin is harder to pull out than ever before. Stopper to prevent blade breakage It prevents the blade from breaking off with too much force. In order to cut cleanly, the cutting edge must hit the cutting board blade firmly