Plamo Improvement Commision Runner in Dock japan NEW

Modeling/assistive modeling tools
Store the runner in the space of one plastic model box.

When building a plastic model, it's common for runners to be scattered around, making it difficult to find the runner you want to use and reducing the efficiency of your model production.
The Runner in Dock is a revolutionary item that increases the efficiency of your plastic model production by making it easy to find, remove, and handle the runner efficiently while minimizing the space for the runner.
It is foldable, so it can be stored neatly without getting in the way after use.

[A compact dock for a box of plastic models].
The product area was designed to be the same as one standard plastic model box.
Stacking the runners high allows you to work in an organized manner without clutter while minimizing runner space.
Up to 8 sets of storage plates can be used for most 1/144 scale kits.

Storage space that can be adjusted to fit the height of the runner
Insert the divider plate into the left and right divider plate slots from the bottom and place the runner.
The plates are designed to be spaced in approximately 1cm increments, so that the next plate can be plugged in on top while matching the height of the runner placed underneath, allowing you to store it while wasting space.
It's plate type, so it's less susceptible to the thickness of the runner and provides more stable storage.

Top surface and base surface where small parts can be placed].
The top and base surfaces of the [Runner in Dock] are flat to prevent loss by placing poly caps, small runners, stickers, etc.

[Work space can be organized neatly]
By using the "runner in dock", the runner does not clutter up the working space, so you can secure a wider and neater working space.

【Foldable for compact storage】.
The [Runner in Dock] can be folded compactly.
The included divider plate can also be stored in its own space, so it takes up less space and gets in the way of the rest of your work.

Also compatible with plastic models with many parts].
By placing two of these products side-by-side, a relatively large-sized plastic model with a large number of parts can be used for almost any kit.
Some oversized kits may not be compatible with this product.

Product Description
Size.
Approx. 242mm x 241mm x 86mm (when assembled)
Accessories
Runner in dock x 1
Divider plate x 16
Material.
Runner tag clip, partition plate: ABS

The image is an image.

(From the Plastic Model Improvement Committee)