Tamiya 1/24 Sports Car Series MERCEDES AMG GT3 japan NEW

"Plastic / car model assembly kit

Total length = 198 mm The picture shows the kit assembled and painted

【Sweeping the world GT race】
Mercedes, GT race of the world crowded world such as Ferrari, Porsche, Lamborghini, Audi etc.
The commercial racing car of the FIA ??GT 3 standard developed for this race is the Mercedes AMG GT 3.
While the base sports car AMG GT is based, the body with the carbon fiber exterior panel mounted in aluminum space frame is lightweight finished, equipped with large rear wing, diffuser and front spoiler.
A 6.3 liter V8 naturally aspirated engine is mounted on the front to drive the rear wheels.
This machine delivered to the leading racing team of the whole world also participated in SUPER GT of Japan from 2016.
In the sports car race, the Blancpain GT series held mainly in Europe, the HTP motor sports team acquired the driver & team title, and in the 2016 Nurburgring 24 Hour race monopolizes 1-4 in the world It is a big success in the race of.
It is a commercially available racing machine indispensable for GT race.

【About the Model】
It is a plastic model assembly kit that reproduces the commercial racing car, Mercedes AMG GT3, developed according to the FIA ??GT3 standard.
★ 1/24 scale, total length 198 mm, full width 87 mm, total height 71 mm (including antenna).
★ Realistically reproduce the glamorous form of long nose ・ short deck, with air outlets opened in bonnet and front and rear fenders.
★ Finish enough for three-dimensional feeling around the legs and the interior.
★ The front grille which integrated the emblem is a plating part.
★ Yellow stripes and AMG logos are prepared with slide marks.

- Air outlets are opened in each part, realistically modeling a powerful form equipped with a large rear diffuser.
・ Reflector of front grille and front and rear light is plating parts.
A nylon mesh is prepared for the air intake part.
・ Carbon patterns such as rear wing are reproduced with slide marks.
- Sharp finish of the air outlet and disc brake of the upper part of the fender.
Center lock nut of the wheel is another part.
・ Reproduce radiator and cooling fans visible from the bonnet air outlet duct.
・ Bucket seat and F1 type steering wheel and pedals are also part of cockpit equipped with roll cage.
- The slit drilled in the exhaust pipe part of the body side is the feature of the 2016 type machine.
・ The marking reproduces the development test in 2016.
Window mask seals and nylon mesh are also available.

(From Tamiya website) "