Tamiya Mini 4WD REV TRAIRONG (FM-A CHASSIS) japan NEW

"Mini 4WD kit.

Total length = 156 mm The picture shows the kit assembled and painted

【Image of Hawk, Thai design contest winning machine machine】
It is a plastic model assembly kit of high performance racer adopting shaft drive four wheel drive.
Try Long is a machine that commercialized the winning work of the Mini 4WD Design Contest held in Thailand.
The car name is derived from the Thai flag "Ton Tri Long" (three color flag).
Red ABS resin body is a hawk motif, aerodynamic design that considers the flow of air.
Equipped between left and right front fender and nose, upper and lower two straightening plates are characteristic.
It is full-scale modeling that makes air taken from the front of the body flow to the side, reminiscent of a real car racing car.
In addition, we prepared a stripe of curved stripes based on three colors of Thai flag, with headlamps that imagined the hawk eyes.

【Adopt FM-A chassis of front motor layout】
Chassis adopted FM - A of front motor layout incorporating aero design.
Since the center of gravity is more than the front of the car body, it is possible to run with a sense of stability even on a course with many ups and downs.
Starting with standard low skid bar made of low friction resin on the lower part of the front, 4 rollers made of low friction resin.
Especially the rear roller has made it 8 mm thick type which increased stability.
In addition, the motor can be easily replaced from the bottom of the chassis, and the setting change is also fast.
Various parts are attached to the aero side stay made with the hint of the sectional shape of the wing of the airplane.
The chassis body is made of ABS resin, the A part such as under panel and skid bar is made of low friction resin.
It is a real car-like finish that unified both in black.
In addition, we set a low height tire on the A spoke wheel with a textured smoke plating.
3.5: 1 super speed gear, with motor.

【Basic Specification】
● Completion length of 156 mm, full width 97 mm, total height 45 mm
● With motor
● Assembly is an inlay type with no adhesive required

【What you need separately】
● Two AA batteries

(From Tamiya website) "