three zero 1/35 Robo Do Griffon (Patlabor) japan NEW

Action Figure (Anime/Science Fiction Character) 1/35 scale Griffon from the Robo-Michi series! From the long-running and popular anime series "Mobile Police Patlabor" comes the experimental prototype reaver "Griffon" made by Shaft Enterprises from threezero's "Robo-do" series! Griffon is a 1/35th scale (24.4cm in height) articulated figure made of ABS, PVC, POM, zinc alloy die-cast, and cloth. The zinc alloy die-cast is used for the movable frame, which provides a total of approximately 60 points of articulation throughout the figure. Cloth is used to cover the elbows, waist, hip joints, and knees, allowing the silhouette of the Griffon to be both reproduced and movable. The cloth is also painted with threezero's signature weathering paint to further enhance the realism of the figure. The "Robo-Do Griffon" is also equipped with various gimmicks to enhance playability. The upper half of the chest part can be lifted up to expose the cockpit, and the abdominal hatch can be deployed forward. The pilot's seat can be exposed by removing the internal block, and the included "Badrinath Haruchand" pilot figure (non-movable) can be seated there. The head part of the Griffon can be lifted up by its collar to reveal the inside of the cockpit. The characteristic giant wing has 4 movable points on each side, allowing for a variety of poses. Even when the wing is boldly posed, the weight of the die-cast zinc alloy frame of the legs will not easily throw it off balance. Four pairs of interchangeable wrist parts for different poses are also included, as well as a common RoboDo action stand. Painted posable figure made of ABS&PVC&POM&zinc alloy (joint covers are made of cloth) 1/35 scale Height: approx. 24.4cm Accessories:. 4 pairs of replaceable wrist parts (1 pair of fists, 1 pair of open hands, 1 pair of grabbing hands, 1 pair of piercing hands), pilot figure (Badrinath Haruchand), RoboDo action stand Sculptor threezero The photos shown may differ slightly from the actual product. Due to the manual coloring process of the products, there may be slight differences in the painting of each product. Please understand this in advance. Due to the nature of the paint, the paint may not be completely dry when the package is opened. If the paint is not dry, place the product in a shady, well-ventilated room for 2~3 days to make sure the painted surface is dry before touching it. If the product is used while it is not dry, it may cause color migration or fingerprint marks. (C) HEADGEAR (From Good Smile Company website)