WAVE HG Fine Nipper (Tip Curved Type)

Modeling / Modeling auxiliary tool
【Gate cut only for plastic model kit】 Precision nipper

- It is a precision nipper that is convenient when cutting plastic parts parts from the gate.
● Pre-curved type suitable for cutting work at a place where you entered or a narrow area
● It is possible to perform a smooth cutting work with 【Single blade type】 with blades on only one side.
● The stopper screw (Imoneji type) that prevents too much grip, and the opening stop pin to prevent excessive opening of the blade are mounted, which suppresses too much hitting of the blades on both sides.
- A hexagonal wrench for adjusting the protective cap and stopper screw convenient for storage is included.

【Product Material】
・ Product Body: Special Steel
・ Grip portion / protective cap: PVC / hexagonal wrench: chrome vanadium steel
Cutting ability
● Gate part of plastic assembly model
(Middle part between runner and parts)
● Plastic bars: Diameter 2 mm or less (recommended)

(please note)
For precision work, attention is required when using.
Because this product corresponds to precision cutting work, there is an unavoidably weak part in terms of strength and durability when compared with general nippers.
Please use the following contents to prevent the breakage of the product and to demonstrate the original performance.
● Do not overload yourself during work, please do with light power.
If you put too much force, the wear of the blade and breakage of the cutting edge are likely to occur.
Be sure to perform cutting work with light force.
● Do not twist or twist the cutting edge when cutting.
Also, please do not drop the product.
It may be dangerous if the blade breaks or the broken cutting edge flies.
● During operation, cutting edges or cuttings may break unintentionally.
For safety, please use protective eyewear, mask, gloves, etc and confirm that there are no people or fragile objects around you.
● It is a product exclusively for gate cutting of general plastic assembly model.
Please use it for cutting plastic parts labeled PS, PE, ABS, PP.
Please do not use it for other hard plastic (transparent / semitransparent PS, polycarbonate, FRP, acrylic resin etc.) or materials above the cutting ability of the product.
● It is not suitable for cut work of materials other than plastics.
Please do not use it.