WAVE HG Detail Punch Trapezoid (2) HT-467 japan NEW

One-touch punching of continuous shapes! A convenient punch for making detail-up parts! These punches are useful for making detail-up parts by yourself. These punches are convenient for making detail-up parts. ●Continuous shapes can be punched out with one touch, making mass production of parts easy. A variety of detail-up parts can be created by arranging the punched material. A utility model has been applied for. Cutting capacity: 0.3mm or less in thickness Target materials] Thin sheets and boards made of plastic (PS only). Thin sheets and boards made of plastic (PS only) and general paper materials. Do not use for materials that are not applicable to the product (ABS, PP, PVC, PE, other flexible plastics, films, etc.) or for materials that exceed the cutting capacity of the product. This product contains a blade. Do not use on materials beyond the cutting capacity of the product. This product contains a blade. The size of each part of the blade is for reference only. The size of the cutting blade is for reference only and may vary slightly. ●When working on thin paper such as Japanese paper, flexible vinyl film, or sheets made of soft plastic (PVC, etc.), it may not work properly even if the thickness is within the cutting capacity. The example of the use image is for reference only. It may be necessary to perform further processing after punching out the material with this product. Product material: ABS/Aluminum alloy This product is a renewal of the HT-436 with the target material (plastics) limited to PS. This product is a renewal of the HT-436 with the target material (plastics) limited to PS. The design of the cutting blade and the size of each part are the same as those of the conventional HT-436. This product is suitable for cutting out general paper and thin plastic (PS only) sheets. This product is suitable for punching general paper and thin plastic (PS only) sheets. When working on thin paper sheets such as Japanese paper, or depending on the type of PS material, it may not be possible to work properly even if the thickness is within the cutting capacity.